2020-07-06, 11:49 AM
Hi,
I have an odd problem with my can bus adapter (Actisense NGT-1).
When Openplotter2 is started chances are 50% that the can bus adapter start sending data. Many times I need to open SK admin and restart SK several times before data starts flowing in. I know that there is data to send as the connected n2k instruments before the Actisense performs normally.
The only error I get at start up is:
Checking serial connections conflicts...
There are conflicts between the following serial connections:
Signal K -> connection ID: ais | device: /dev/ttyOP_ais
This is also odd as the ais input works perfect from start every time. The message doesn't tell with what the conflict is about. When, after restarting SK the can adapter is finally working the conflict message about the ais adapter is still there.
Where do I find logs that can give more details of what is going on?
Cheers,
Pär W
I have an odd problem with my can bus adapter (Actisense NGT-1).
When Openplotter2 is started chances are 50% that the can bus adapter start sending data. Many times I need to open SK admin and restart SK several times before data starts flowing in. I know that there is data to send as the connected n2k instruments before the Actisense performs normally.
The only error I get at start up is:
Checking serial connections conflicts...
There are conflicts between the following serial connections:
Signal K -> connection ID: ais | device: /dev/ttyOP_ais
This is also odd as the ais input works perfect from start every time. The message doesn't tell with what the conflict is about. When, after restarting SK the can adapter is finally working the conflict message about the ais adapter is still there.
Where do I find logs that can give more details of what is going on?
Cheers,
Pär W