OpenPlotter 3 roadmap

[Sailoog]

Hi skynavigator. Honestly I have not understood your proposal or your plan, could you be more specific?

Could you show us your modifications in the openplotter-gpio repo at least to see if they are compatible with the project line?

You can make pull requests to github at any time but they will have more chances of being accepted if we have discussed them before: https://openplotter.readthedocs.io/en/3....orate.html

[Paul M]

I recently saw that notifications v3.0.4 had been released and upgraded to it, ran it to complete the install and now get the following error: Error reading Signal K Zones configuration. Is this plugin installed and enabled?

Looking at signal k, the plug-in is installed and going to plugin configuration and enabling it gives an error:Failed to start: Cannot read properties of undefined (reading map).

Hoping this is helpful but otherwise I’ll await the docs!

I see good and rapid progress is being made with a number of point releases today , I updated including notifications app to v3.0.5 and after authorising in signal k, I just get the message ‘no zones found’ which I think I need to set up in the signal k zones plugin.

[Sailoog]

We are in beta now!

New images for OpenPlotter v3 Starting 32 and 64 bit has been released today:

https://cloud.openmarine.net/s/mxrBi5K7zRj2gDq

Translations have been already applied to this beta version, please check and modify contents in Crowdin if needed.

OpenPlotter v3 Headless beta and docs beta will follow.

From now on, we should report any bug in the bugs forum instead of this thread.: https://forum.openmarine.net/forumdisplay.php?fid=4

[Paul M]

Thanks Sailoog.
Just a thought — would it be advantageous to have a new topic for op3 bug reports as op2 bug reports may still continue to be posted?
P. S. I see the op3 doc on the website has the network app included but the doc on the beta distribution doesn’t.

[Sailoog]

I think using the OP version in the subject or the body would be enough, there are very few bugs for OP 2.

The documentation is a bit out of sync right now but it will be up to date in a few days.

[Paul M]

Ok, thanks Sailoog. I know you have been busy on the beta code release.

[Sailoog]

Images for OpenPlotter v3 Headless beta: https://cloud.openmarine.net/s/dynLaCPMfoo6PT9

[turnipisum]

oh where did my message go!

[abarrow]

Oops! We had a lot of spam this morning and your message might have been caught up in the sweep! Apologies. Can you please repost?

[turnipisum]

Oops! We had a lot of spam this morning and your message might have been caught up in the sweep! Apologies. Can you please repost?

Oh ok no worries, thanks

---

---

Hi

Manual install on pi4 8gb bullseye got as far as settings install but it will not update when at source is clicked.
FAILED. Unknown system: raspbian