2022-12-22, 06:31 AM
Hi,
I enabled i2c and I can see my sensors, but System Check says:
Checking I2C sensors... | I2C enabled | openplotter-i2c-read not running | Access to Signal K server validated
↳Your Raspberry Pi is too old.
pi@openplotter:~ $ sudo i2cdetect -y 1
0 1 2 3 4 5 6 7 8 9 a b c d e f
00: -- -- -- -- -- -- -- --
10: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
20: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
30: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
40: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
50: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
60: -- -- -- -- -- -- -- -- -- 69 -- -- -- -- -- --
70: -- -- -- -- -- -- 76 --
pi@openplotter:~ $
My model according to https://elinux.org/RPi_HardwareHistory
c03112
Q2 2019
4 Model B
1.2
4 GB
(Mfg by Sony)
Is that really too old??
I can see in the code (the only reference I could find to "Your Raspberry Pi is too old" with Google), that this message is shown, when the /dev/i2c-0 is in "ls /dev/i2c*"
pi@openplotter:~ $ ls /dev/i2c*
/dev/i2c-0 /dev/i2c-1 /dev/i2c-10 /dev/i2c-20 /dev/i2c-21 /dev/i2c-22
pi@openplotter:~ $
What can I do?
I enabled i2c and I can see my sensors, but System Check says:
Checking I2C sensors... | I2C enabled | openplotter-i2c-read not running | Access to Signal K server validated
↳Your Raspberry Pi is too old.
pi@openplotter:~ $ sudo i2cdetect -y 1
0 1 2 3 4 5 6 7 8 9 a b c d e f
00: -- -- -- -- -- -- -- --
10: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
20: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
30: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
40: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
50: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
60: -- -- -- -- -- -- -- -- -- 69 -- -- -- -- -- --
70: -- -- -- -- -- -- 76 --
pi@openplotter:~ $
My model according to https://elinux.org/RPi_HardwareHistory
c03112
Q2 2019
4 Model B
1.2
4 GB
(Mfg by Sony)
Is that really too old??
I can see in the code (the only reference I could find to "Your Raspberry Pi is too old" with Google), that this message is shown, when the /dev/i2c-0 is in "ls /dev/i2c*"
pi@openplotter:~ $ ls /dev/i2c*
/dev/i2c-0 /dev/i2c-1 /dev/i2c-10 /dev/i2c-20 /dev/i2c-21 /dev/i2c-22
pi@openplotter:~ $
What can I do?