Hi yall,
Happy to share this iteration of a case for the most-demanded sandwich : Pi5 + NVMe Bottom and MacArthur HAT.
This case fits Pimoroni, Pineberry and Geekworm NVMeM.2 SSD bottom HATs.
You should not need additional screws other than the one from the bottom hat + MacArthur provided ones.
I had to make some design choices regarding various aspects such as the power button, SD card, NVMe or cam/display ribbon ports access.
Feel free to share feedback or comments on it.
![[Image: large_display_splitview_Pi5_%2B_NVMe_Bot...ase_v4.png]](https://cdn.thingiverse.com/assets/d0/07/f2/80/39/large_display_splitview_Pi5_%2B_NVMe_Bottom_Hat_%2B_MacArthur_Hat_Case_v4.png)
The files and additional view are available here : https://www.thingiverse.com/thing:6514685
Updated on the 11/01/2025 (see later posts in this thread): https://www.thingiverse.com/thing:6907924
I've done a couple of 3D prints of it to tighten the fit, the assembly should hold firmly inside the case once enclosed with the 3 screws.
Most ports are flush with the outer case and easily accessible.
NB: I couldn't try the assembly with the power module on and connected. It might need some tweak if the power module is heating a lot
Happy Sunday!
Happy to share this iteration of a case for the most-demanded sandwich : Pi5 + NVMe Bottom and MacArthur HAT.
This case fits Pimoroni, Pineberry and Geekworm NVMeM.2 SSD bottom HATs.
You should not need additional screws other than the one from the bottom hat + MacArthur provided ones.
I had to make some design choices regarding various aspects such as the power button, SD card, NVMe or cam/display ribbon ports access.
Feel free to share feedback or comments on it.
![[Image: large_display_splitview_Pi5_%2B_NVMe_Bot...ase_v4.png]](https://cdn.thingiverse.com/assets/d0/07/f2/80/39/large_display_splitview_Pi5_%2B_NVMe_Bottom_Hat_%2B_MacArthur_Hat_Case_v4.png)
The files and additional view are available here : https://www.thingiverse.com/thing:6514685
Updated on the 11/01/2025 (see later posts in this thread): https://www.thingiverse.com/thing:6907924
I've done a couple of 3D prints of it to tighten the fit, the assembly should hold firmly inside the case once enclosed with the 3 screws.
Most ports are flush with the outer case and easily accessible.
NB: I couldn't try the assembly with the power module on and connected. It might need some tweak if the power module is heating a lot
Happy Sunday!