2016-05-22, 11:14 AM
It seems that this happens with more devices:
- Plotter Raymarine C90W
- Display Raymarine ST60
Nmea 0183 Serial Adaptor Problem
|
2016-05-22, 11:14 AM
It seems that this happens with more devices:
2016-05-28, 10:53 PM
Same thing with Raymarine A95 Plotter. + and - are reversed. I can't say wether it is a fault in the plotter documentation or with the writing on the USB2ser adpator.
Rx- = yellow cable from plotter nmea out Rx+= brown cable from plotter nmea out Martin
2016-05-31, 11:13 AM
This has been reported only with Raymarine products. I bet on a different "conception" of Raymarine labelling their products.
2016-06-14, 08:32 PM
Also had this problem with an ICOM MXA-5000. Had to reverse the + and -. The device then fully flashed green instead of being in a weird "dimming" state.
2016-06-15, 11:52 AM
So at this point I am not sure where is the problem either devices or converters. Most of people use the normal polarity. I will add a note in documentation recommending reversing polarity if something does not work. Since the device is protected against this, there is not problem testing.
|
« Next Oldest | Next Newest »
|