2018-05-30, 01:05 PM
(This post was last modified: 2018-05-30, 01:09 PM by mikedeflieslife.)
Hi,
I'm new to Openplotter and the Raspberry Pi 3b+
I recently installed the 28 May build, and have a few little things I need to sort out that I haven't quite found the answers to whilst searching.
1) How do I completely turn the access point off? I do not want Openplotter to be an access point, instead it should just be part of my larger network. I've been into the Network tab and set it as client, but even after a reboot. It is still broadcasting on 10.10.10.1 - I would like one or both of the radios to be available to connect to networks of my choosing.
2) I already my NMEA and NMEA0183 data broadcast over wifi. What exactly do I have to do to configure Openpotter to recieve this data? In openCPN it's as simple as just setting up a new connection and inputting the IP address and the port, but I can't find a similar setting in Openplotter itself.
Thanks in advance
EDIT: Sorry Mods, can you please move this to the "How do I..." forum?
I'm new to Openplotter and the Raspberry Pi 3b+
I recently installed the 28 May build, and have a few little things I need to sort out that I haven't quite found the answers to whilst searching.
1) How do I completely turn the access point off? I do not want Openplotter to be an access point, instead it should just be part of my larger network. I've been into the Network tab and set it as client, but even after a reboot. It is still broadcasting on 10.10.10.1 - I would like one or both of the radios to be available to connect to networks of my choosing.
2) I already my NMEA and NMEA0183 data broadcast over wifi. What exactly do I have to do to configure Openpotter to recieve this data? In openCPN it's as simple as just setting up a new connection and inputting the IP address and the port, but I can't find a similar setting in Openplotter itself.
Thanks in advance
EDIT: Sorry Mods, can you please move this to the "How do I..." forum?