2016-08-18, 03:19 PM
Hi, in opencpn, I can't always have my position and ais signal...
Gps works quite always but it don't when AIS work and viceversa
When ais work I have gps data in inspector but not in opencpn
I Made test also with a gps usb antenna, it seems more stable but same problem
My configuration is:
Rpi3
Gps BT antenna emtac
Daisy AIS reciver
Openplotter 8.0
If I open openplotter in Debug mode, the terminal say 'DEVLINKS'
I did this
http://forum.openmarine.net/printthread.php?tid=79
to install the BT antenna
To install daisy I add a serial in openplotter NMEA 0183 tab in /Dev/ttyACM0 at 38400 baud
Thanks a lot
Gps works quite always but it don't when AIS work and viceversa
When ais work I have gps data in inspector but not in opencpn
I Made test also with a gps usb antenna, it seems more stable but same problem
My configuration is:
Rpi3
Gps BT antenna emtac
Daisy AIS reciver
Openplotter 8.0
If I open openplotter in Debug mode, the terminal say 'DEVLINKS'
I did this
http://forum.openmarine.net/printthread.php?tid=79
to install the BT antenna
To install daisy I add a serial in openplotter NMEA 0183 tab in /Dev/ttyACM0 at 38400 baud
Thanks a lot