Hi OpenPlotterers,
I just came across this amazing project and luckily had still two unemployed RasPi B+ on board, so downloaded the OpenPlotter 0.8.0 IMG and set it up (via TightVNC through ethernet, later USB WiFi connected to Android hotspot).
I tried both RasPi's, two virgin 16GB SD cards, freshly formatted, but on both systems (logged in via TightVNC and / or RDP from Windows10), the INSPECTOR crashes. But only, if a serial port is activated, and it seems like it's receiving some data (usually one field is filled with a tiny bit of data before it hangs). KPLEX is working fine, I'm streaming AIS&GPS data to my laptop, marinetraffic, AISHUB. I get no error message when running OP in terminal, as I assume it's only an inspector problem.
It doesn't matter if I attach a USB GPS or my em-trak B100 AIS transceiver via USB, both result in the same hang up on both RaspberryPis.
Also, I can't start OpenCPN. When I try, I don't even see it in "top" or task manager.
zyGrib on the other hand is working fine, though.
Would be happy if someone could point me in the right direction of how to fix these problems, I intend to make this my primary data hub.
Ahoy
Axel
I just came across this amazing project and luckily had still two unemployed RasPi B+ on board, so downloaded the OpenPlotter 0.8.0 IMG and set it up (via TightVNC through ethernet, later USB WiFi connected to Android hotspot).
I tried both RasPi's, two virgin 16GB SD cards, freshly formatted, but on both systems (logged in via TightVNC and / or RDP from Windows10), the INSPECTOR crashes. But only, if a serial port is activated, and it seems like it's receiving some data (usually one field is filled with a tiny bit of data before it hangs). KPLEX is working fine, I'm streaming AIS&GPS data to my laptop, marinetraffic, AISHUB. I get no error message when running OP in terminal, as I assume it's only an inspector problem.
It doesn't matter if I attach a USB GPS or my em-trak B100 AIS transceiver via USB, both result in the same hang up on both RaspberryPis.
Also, I can't start OpenCPN. When I try, I don't even see it in "top" or task manager.
zyGrib on the other hand is working fine, though.
Would be happy if someone could point me in the right direction of how to fix these problems, I intend to make this my primary data hub.
Ahoy
Axel