2019-06-16, 01:16 PM
I am having some trouble getting WiFi (client or access point) going on my fresh (NOOBS) install of OpenPlotter.
Did it the "NOOBS" way, ran the updates for OpenPlotter and OpenCPN, added a Moitessier HAT, followed the install procedure, everythign is good from that side ..
WiFi though .. thats another matter, it seems what we call in technical terms to be "screwed".
My network setup is RPi3+: AP+ client
sharing: wlan0
but from the network icon on the task bar instead of a list of access points, I just get "no wireless interfaces found"
rfkill list all looks fine, nothing blocked.
iwconfig shows wlan1, not wlan0 ... I have tried configuring openplotter as sharing both wlan0 and wlan1 as the shared device, neither yields a different result.
wpa_supplicant has GB set as the country, but the wpa_supplicant service does nto appear to be running .. and I don't seem to be able to start it:
Failed to start wpa_supplicant.service: Unit wpa_supplicant.service is masked
ideas?
Did it the "NOOBS" way, ran the updates for OpenPlotter and OpenCPN, added a Moitessier HAT, followed the install procedure, everythign is good from that side ..
WiFi though .. thats another matter, it seems what we call in technical terms to be "screwed".
My network setup is RPi3+: AP+ client
sharing: wlan0
but from the network icon on the task bar instead of a list of access points, I just get "no wireless interfaces found"
rfkill list all looks fine, nothing blocked.
iwconfig shows wlan1, not wlan0 ... I have tried configuring openplotter as sharing both wlan0 and wlan1 as the shared device, neither yields a different result.
wpa_supplicant has GB set as the country, but the wpa_supplicant service does nto appear to be running .. and I don't seem to be able to start it:
Failed to start wpa_supplicant.service: Unit wpa_supplicant.service is masked
ideas?