I got a rough working masthead unit using a nRF24L01+ Transceiver.
I wanted to just send 12V up the mast but receive Wind direction and speed and control anchor light.
data is sent to Openplotter via Signal K and switch hard wired to RPI 3 GPIO 25 for light.
here is a link to the project. github dmdelorme
uses less than .02 amps
anchor light uses .2amps
I wanted to just send 12V up the mast but receive Wind direction and speed and control anchor light.
data is sent to Openplotter via Signal K and switch hard wired to RPI 3 GPIO 25 for light.
here is a link to the project. github dmdelorme
uses less than .02 amps
anchor light uses .2amps