This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Connecting NMEA Wind data from NASA Clipper
#3
(2018-04-15, 12:29 PM)jim321 Wrote: thats strange ..
the guys are busy working on the next release and looks like they are addressing this .
https://github.com/sailoog/openplotter/c...4c5fad0dbb

We are putting a lot of hope as always in the next version but it is good, i just hope that they are aware of this behavior so that the catch these issues too  ...  anything i should do? I mean, if i was at my work i would report a JIRA, a bug.

It /is/ a very strange behavior. Somebody mentioned that NASA instruments still run NMEA0183 V1, unbalanced and without checksum... but i can find no information verifying that.
As long as i can see the messages in auto-setup i should be on safe ground reception-wise but then how to make these messages show up iin signal K ...have no idea.

/M
Reply


Messages In This Thread
RE: Connecting NMEA Wind data from NASA Clipper - by Smartell - 2018-04-15, 04:41 PM

Forum Jump:


Users browsing this thread: 4 Guest(s)