Hello,
I am setting up a network of RPI 3B+ for my sailing boat.
2nd is client via eth0 of 1st : no problem, wlan0/1 : off (dnsmasq disable)
3rd is client via eth0 of 1st and via wlan0/1 connect to Iridium GO Wifi AP : no problem (dnsmasq disable)
but with the 1st : problem I cannot find a cause and than a solution.
Structure is exactly as shown on picture 2 on https://docs.sailoog.com/openplotter-v1-x-x/network
In Openplotter/Network :
Network mode is : Rpi3+:AP + client + bridge eth0
Shared internet : wlan0
(dnsmasq enable)
Connexion is ok, but when I try to change the Wifi AP on wlan0, I have only on top right the message "Click here to set Wi-Fi country" and not the list of available AP.
I have to set Network mode to client to have the list and be able to change network and then reconfigure to Rpi3+:AP + client + bridge eth0.
A bit ennoying. Any idea to solve this problem ?
Have a nice day
I am setting up a network of RPI 3B+ for my sailing boat.
2nd is client via eth0 of 1st : no problem, wlan0/1 : off (dnsmasq disable)
3rd is client via eth0 of 1st and via wlan0/1 connect to Iridium GO Wifi AP : no problem (dnsmasq disable)
but with the 1st : problem I cannot find a cause and than a solution.
Structure is exactly as shown on picture 2 on https://docs.sailoog.com/openplotter-v1-x-x/network
In Openplotter/Network :
Network mode is : Rpi3+:AP + client + bridge eth0
Shared internet : wlan0
(dnsmasq enable)
Connexion is ok, but when I try to change the Wifi AP on wlan0, I have only on top right the message "Click here to set Wi-Fi country" and not the list of available AP.
I have to set Network mode to client to have the list and be able to change network and then reconfigure to Rpi3+:AP + client + bridge eth0.
A bit ennoying. Any idea to solve this problem ?
Have a nice day