2018-09-26, 01:06 AM
(This post was last modified: 2018-09-26, 01:09 AM by seandepagnier.)
Using an ESC is simpler to build because the hbridge used is already part of the ESC, you just connect power, ground, and signal wire.
If you don't mind using lots of components and making many more solder connections, then yes I do make hbridge controller for hydraulic pumps:
https://www.youtube.com/watch?v=IMqUmcTbQOE
This is more efficient and allows you to design for any voltage and current needed but takes a lot more work to build.
If you don't mind using lots of components and making many more solder connections, then yes I do make hbridge controller for hydraulic pumps:
https://www.youtube.com/watch?v=IMqUmcTbQOE
This is more efficient and allows you to design for any voltage and current needed but takes a lot more work to build.