2018-11-30, 04:40 PM
Hi all,
I am happy to say the first pcbs have found a new home.
I have completely forgotten that the pcb has soldering pads for
SCL/SDA and TX from the BLE113.
So of course you can hook it up directly to the I2C pins of the RPi.
This means you don´t need the CC debugger and TAG connect
cable. Three simple wires will do the job too.
If you are not interested in the franklin sensor, you can still use the
board to connect I2C sensors to it and send the data via BLE to the
RPi using Node Red.
All the best
Chris
I am happy to say the first pcbs have found a new home.
I have completely forgotten that the pcb has soldering pads for
SCL/SDA and TX from the BLE113.
So of course you can hook it up directly to the I2C pins of the RPi.
This means you don´t need the CC debugger and TAG connect
cable. Three simple wires will do the job too.
If you are not interested in the franklin sensor, you can still use the
board to connect I2C sensors to it and send the data via BLE to the
RPi using Node Red.
All the best
Chris