This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Epsolar plugin for SignalK
#1
I just finshed a little bit of python code that reads 1 to 4 epsolar tracer charge controllers. It works with the
the sk-plugin-python-demo.
The link to my plugin is Epsolar plugin.
I still has a few issues but it works.
It sends data to the SignalK server and has some configuration set up in the plugin config.
If it sees a epsolar device connected to the RPI via usb. It will configure, connect and send data.
Reply
#2
well after a bit of a melt down here is the new link.... https://github.com/dmdelorme/sk-plugin-p...psolar.git
Reply
#3
This serves also as an exsmple of a Signal K server plugin written in Python. There’s tons of Python for interfacing with sensors, so now you can embed that code in the server, including configuration in the server admin user interface. And the plugin can be distributed via the App store.


Sent from my iPhone using Tapatalk
Reply
#4
Its been a while since this thread was last posted but I am interested in connecting my EPSolar AN series MPPT controller to my RPi setup. Can it be used with the RPi4 and OPV2?

Thanks
Reply
#5
yes but, I have an issue with the code and need to sit and do some rewriting. there is an issue with the config and some issues with the epsolar lib.
Reply
#6
(2020-03-05, 01:08 AM)ddelorme Wrote: yes but, I have an issue with the code and need to sit and do some rewriting. there is an issue with the config and some issues with the epsolar lib.

Thanks for the quick response. Perhaps you can post back when you have had time to sort it out.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)