2019-03-18, 08:16 PM
I had the same problem.
I finaly solved it programming the fuses on the nano with the Raspberry Pi.
Just don´t remember exactly how but here is the link that helped me:
https://learn.adafruit.com/program-an-av...s?view=all
You have to connect 6 cables from the arduin (5v, gnd, mosi, miso ......) to the GPIO Pins of the PI
Important is that the GPIO-Pins are the ones that are defined by the AVRdude programm on the PI.
I also uploded the motor.ino scetch in HEX with the AVRDUDE.
Good luck and save sailing
Andreas
I finaly solved it programming the fuses on the nano with the Raspberry Pi.
Just don´t remember exactly how but here is the link that helped me:
https://learn.adafruit.com/program-an-av...s?view=all
You have to connect 6 cables from the arduin (5v, gnd, mosi, miso ......) to the GPIO Pins of the PI
Important is that the GPIO-Pins are the ones that are defined by the AVRdude programm on the PI.
I also uploded the motor.ino scetch in HEX with the AVRDUDE.
Good luck and save sailing
Andreas