2020-04-04, 04:51 PM
Just asked Sean same question.
You can wire it into pin 11 on the arduino (motor controller) using 2 resistors and a mosfet. I ordered a logic level mosfet with 5 volts gate, expect deliverance next week. A 560 ohm resistor between gate and io pin to limit the current from the pin and a 10K ohm resitor between gate and ground.
Cheers,
Matthieu
You can wire it into pin 11 on the arduino (motor controller) using 2 resistors and a mosfet. I ordered a logic level mosfet with 5 volts gate, expect deliverance next week. A 560 ohm resistor between gate and io pin to limit the current from the pin and a 10K ohm resitor between gate and ground.
Cheers,
Matthieu