2019-08-30, 10:04 PM
(This post was last modified: 2019-08-30, 10:23 PM by glowntiger.)
Now i have testet the digital inputs. All works fine.
Also I have tested a mcp23017 on the i2c connector. Also works fine.
what should I plan? 16x 8-28V digit. In, 16x 8-28V digital out (450mA) and 4x Analog in 0-10V? I would like to make a hat for the controler…. Or do you think we need more?
I have tested the RS422. Works realy good with NMEA0183 devices. Tested with Furuno RO4800 (AIS and UKW), GPS, and ST4000+ Pilot.
Now i only have to test the MCP CAN for NMEA2K
Here some pictures with case:
What I change is the position of the Input Terminal. This is at the Moment under the Pi...
This is the new position:
Also I have tested a mcp23017 on the i2c connector. Also works fine.
what should I plan? 16x 8-28V digit. In, 16x 8-28V digital out (450mA) and 4x Analog in 0-10V? I would like to make a hat for the controler…. Or do you think we need more?
I have tested the RS422. Works realy good with NMEA0183 devices. Tested with Furuno RO4800 (AIS and UKW), GPS, and ST4000+ Pilot.
Now i only have to test the MCP CAN for NMEA2K
Here some pictures with case:
What I change is the position of the Input Terminal. This is at the Moment under the Pi...
This is the new position: