2019-10-08, 12:33 PM
(2019-10-08, 09:05 AM)glowntiger Wrote:(2019-10-07, 02:55 PM)jim321 Wrote: after a closer look the 12v area could interfere with the compass on the Moitessier hat.so a cable would move it away from that.
i guess it will need to be tested ..hope it works.
Hi Jim,
Thanks for the advice....
why do you think this? Because of the step down converter or the 12v conductor track? I can move the track under the pcb and shirm with a gnd plane. But first I will check if there are any interference..... I think the interference of the pi is bigger? The mcs is far away from the moitessier.... the pi is between the moitessier and the mcs....
i dont know if it will have any effect at all. i just wanted to point out a potential problem.
you will have to test it out with a moitessier hat. like i said it could be moved with a cable.
your board is looking good..