2019-12-03, 09:07 AM
(This post was last modified: 2019-12-03, 09:11 AM by glowntiger.)
Hi Max,
go on your Pi and type:
to delete the folder.
then load the new git data:
then go to the folder:
and install:
now you can start the openplotter APP:
there is a new service in the background (openplotter-MCS-asd) if you enable the autoshutdown in the app, the Pi shuts down after power off the +12V enable Terminal.
You must one time start the app and push save for starting the Service. Until now the app is not handle by openplotter... I hope sailoog do this the next time.
The driver issue is a timing problem of the adresses. I have change the adress of the third sc16is752 on the hardware side. I have order 20 new MCS an they should arrived the next days. At the moment you can only use 4 of the 6 NMEA0183 ports.
All who have get a prototype board gets a new MCS if availible....
https://github.com/raspberrypi/linux/issues/3340
here you find info´s to the issue
go on your Pi and type:
Code:
sudo rm -r openplotter-MCS
to delete the folder.
then load the new git data:
Code:
git clone https://github.com/Thomas-GeDaD/openplotter-MCS
Code:
cd openplotter-MCS
and install:
Code:
sudo python3 setup.py install
now you can start the openplotter APP:
PHP Code:
openplotter-MCS
there is a new service in the background (openplotter-MCS-asd) if you enable the autoshutdown in the app, the Pi shuts down after power off the +12V enable Terminal.
You must one time start the app and push save for starting the Service. Until now the app is not handle by openplotter... I hope sailoog do this the next time.
The driver issue is a timing problem of the adresses. I have change the adress of the third sc16is752 on the hardware side. I have order 20 new MCS an they should arrived the next days. At the moment you can only use 4 of the 6 NMEA0183 ports.
All who have get a prototype board gets a new MCS if availible....
https://github.com/raspberrypi/linux/issues/3340
here you find info´s to the issue