2019-12-03, 03:33 PM
(2019-12-03, 09:07 AM)glowntiger Wrote: Hi Max,
go on your Pi and type:
Code:sudo rm -r openplotter-MCS
to delete the folder.
then load the new git data:
then go to the folder:Code:git clone https://github.com/Thomas-GeDaD/openplotter-MCS
Code:cd openplotter-MCS
and install:
Code:sudo python3 setup.py install
now you can start the openplotter APP:
PHP Code:openplotter-MCS
there is a new service in the background (openplotter-MCS-asd) if you enable the autoshutdown in the app, the Pi shuts down after power off the +12V enable Terminal.
You must one time start the app and push save for starting the Service. Until now the app is not handle by openplotter... I hope sailoog do this the next time.
The driver issue is a timing problem of the adresses. I have change the adress of the third sc16is752 on the hardware side. I have order 20 new MCS an they should arrived the next days. At the moment you can only use 4 of the 6 NMEA0183 ports.
All who have get a prototype board gets a new MCS if availible....
https://github.com/raspberrypi/linux/issues/3340
here you find info´s to the issue
Hi, I followed the instructions but I must have been wrong, see photo. I book for the new card and I hope that in the meantime Sailoog and Rocco make progress. I hope everything is ready for spring and try it all on my boat. Ok, winter is still long, there's time ... good job everyone!
[img][/img]
[img][/img]