2020-05-23, 05:47 PM
(2020-05-23, 04:16 PM)niklun Wrote:(2020-05-19, 03:07 PM)glowntiger Wrote: Hi Nicola,
The setup for the can(nmea2000) must be done in the can app of openplotter. There you must setup the mcp2515. Here is a video:
https://m.youtube.com/watch?v=w4nGNWhy_9c
It's in german but beginning at 2:45 you see how to configure the can. There you also see the incoming data with candump.
At the first entry in this thread you find the most instructions.... ;-)
If you need further help, let me know....
Thomas, thank you. I need help.
I did what you recommended, the setting you told me but I still encountered problems and I don't see the data. Just for a moment I only had data on candump but no data on both the Raymarine i60 and opencpn and / or on signal K (without having changed the connections). I summarize the hardware configuration: Raymarine i60 (seatalk NG) to the can bus of the MCS (I only connected the can-L and can-H since the i60 is self-powered).
Then when the setting was made, having also the Moitesier HAT2 mounted, the longitudinal and transversal roll data (pypilot) disappeared, as if it were in contrast with the MCS bus can.
I don't understand anything anymore. I'm not very experienced, but I wish I could make everything work.
Nicola L.
Hi, see attachment.