2020-05-24, 01:33 PM
(2020-05-24, 11:14 AM)niklun Wrote: Do I have to work and create software connections on Signal K to make it receive data and transmit it? I mean, once the terminals are connected to the board, after setting the Can Bus, do I have nothing else to do?
Devo lavorare e creare delle connessioni software su Signal K per fargli ricevere dati e trasmetterli ? Voglio dire, una volta collegati i terminali alla scheda, settato il Can Bus non ho altro da fare ?
Yes, you have to go to Plugin config and set up what you need. I had to study a lot too and I still have a lot to learn in SignalK. Good job and good wind, always!
(Si, devi andare in Plugin config e impostare cio' che ti serve. Ho dovuto studiare parecchio anch'io ed ho ancora parecchio da inparare in SignalK. Buon lavoro e buon vento, sempre!)