2020-06-09, 05:04 PM
Hi,
ST1 is availible in the app since 2.1.8 (published today)
be sure pigpio is installed:
Connect the yellow st1 wire to one of the Inputs: (In1-In4)
In the widget you can chose wich Input you use. On the Data-Output tab you can chosse the UDP Port.
The best way I think is to use SignalK. Make a udp Connection with the Port you choose and set NMEA0183 Data. Then you get all Data in Signal K. An $STALK parser is in the NMEA0183 SignalK app intigratet.
The reason why you only recieve data from the bus is the electric site and owed it that pigpio can only read bitbanging seatalk1!
ST1 is availible in the app since 2.1.8 (published today)
be sure pigpio is installed:
Code:
sudo install pigpio
Connect the yellow st1 wire to one of the Inputs: (In1-In4)
In the widget you can chose wich Input you use. On the Data-Output tab you can chosse the UDP Port.
The best way I think is to use SignalK. Make a udp Connection with the Port you choose and set NMEA0183 Data. Then you get all Data in Signal K. An $STALK parser is in the NMEA0183 SignalK app intigratet.
The reason why you only recieve data from the bus is the electric site and owed it that pigpio can only read bitbanging seatalk1!