2020-09-22, 01:16 PM
Here you find informations of the updatet 1.5 board...:
https://www.gedad.de/2020/09/20/gedad-mc...te-to-1-5/
Key facts:
Already available:
• Easy-to-use all-round adapter board for Marine application
• Combines different interfaces
• Usable with Raspberry Pi 3,4
• Large inpu tvoltage range(8-28V)
• Integrated 5V Power adapter
• Autoshutdown for power down the Pi and shutdown the board
• 6x NMEA0183® compatible interfaces (configurable as input or output)
• 1x NMEA2000® compatible interface
• 1x 1-Wire® interface with real 1-Wire® standard
• 1x 5V tolerant I²C® interface
• 4x digital Inputs
• Ready to use open source app for OpenPlotter
Whats New?:
• SignalK Intigration
• Sealtalk1 reading
• Frequenz measurement (through In1-In4) for RPM / Frequenz (Terminal W of the Alternator or Sensor) (at the moment only intigrated in Openplotter)
Whats planed?:
• I/O board with 8 Inputs (8-28V) and 8 Outputs (8-28V / 500mA)
• Analog Input board with 4 Inputs. For measure Voltage 12V, measure Shunt diff Voltage and measure Sensor Inputs (0-300Ohm)
=> It is possible to wire 4 of this boards to the MCS
• Compass and Sensor board
https://www.gedad.de/2020/09/20/gedad-mc...te-to-1-5/
Key facts:
Already available:
• Easy-to-use all-round adapter board for Marine application
• Combines different interfaces
• Usable with Raspberry Pi 3,4
• Large inpu tvoltage range(8-28V)
• Integrated 5V Power adapter
• Autoshutdown for power down the Pi and shutdown the board
• 6x NMEA0183® compatible interfaces (configurable as input or output)
• 1x NMEA2000® compatible interface
• 1x 1-Wire® interface with real 1-Wire® standard
• 1x 5V tolerant I²C® interface
• 4x digital Inputs
• Ready to use open source app for OpenPlotter
Whats New?:
• SignalK Intigration
• Sealtalk1 reading
• Frequenz measurement (through In1-In4) for RPM / Frequenz (Terminal W of the Alternator or Sensor) (at the moment only intigrated in Openplotter)
Whats planed?:
• I/O board with 8 Inputs (8-28V) and 8 Outputs (8-28V / 500mA)
• Analog Input board with 4 Inputs. For measure Voltage 12V, measure Shunt diff Voltage and measure Sensor Inputs (0-300Ohm)
=> It is possible to wire 4 of this boards to the MCS
• Compass and Sensor board