Server Hardware for openplotter?

[gniersma]

thanks for your quick response.

how do you get the nmea0183out data to the sentence event?

Sorry don't understand this question.
I followed The configuration examples: https://openplotter.readthedocs.io/en/la...mples.html  (Input and output data) in my case using a separate interface ttysc5 (alias ttyOP_ais)  as input and ttysc2 (alias ttyOP_AP) as output.
 

If the TX LED did not flash, signalk did not send anything to this port. The RX led must flash according to the incomming data.

 don't see any Led's flashing. I've version MCS 1.2 are you sure LED's are on this board?  Understand that this was an enhancement in version 1.5   

According to my experience it is easyer to use the serial ports in signalk without the serial app....

I checked within the Signal K server the connections. they looked oke to me.

I have take a look in the cb200 manual. The device did have rs232/485. How do you have connected it?

I know you can connect both on RS232 and on NMEA (RS422) I'm sure i'm used NMEA Rs422, connecting the wires on A and B terminals of the MCS board.

If necessary i can provide a copy of the signal-K server configuration via a back-up file.

Help is appreciated

thx G.