Server Hardware for openplotter?

[flybob]

The I²C Adress 0X18 is the 1-wire Master. We use a "real" 1-Wire, not a decieved of the Pi.
What kind of issue you get with the installation script?
You can check: are the module entrys available?:
In 

Code:

/etc/modules/

are there the Modules "ds2482" and "wire"
Further is the systemd running??

Code:

sudo systemctl status mcsowire.service

You have an "old" System or a fresh bullseye?
Else, if you want, i can take a look on your system with anydesk.

Does it matter is rPi 1w is enabled or disabled in rPi configuration?

This is an old system that has been running for over a year and updated from time to time.

I've got VNC already running, could we do it that way?



pi@openplotter:~ $ cat /etc/modules
# /etc/modules: kernel modules to load at boot time.
#
# This file contains the names of kernel modules that should be loaded
# at boot time, one per line. Lines beginning with "#" are ignored.


ds2482
i2c-dev
wire
i2c_dev


pi@openplotter:~ $ sudo systemctl status mcsowire.service
● mcsowire.service - MCS owire start service
   Loaded: loaded (/etc/systemd/system/mcsowire.service; enabled; vendor preset: enabled)
   Active: inactive (dead) since Wed 2022-01-19 04:06:41 CET; 17h ago
  Process: 809 ExecStart=/bin/sh -c echo ds2482 0x18 > /sys/bus/i2c/devices/i2c-1/new_device (code=exited, status=0/SU
 Main PID: 809 (code=exited, status=0/SUCCESS)

Warning: Journal has been rotated since unit was started. Log output is incomplete or unavailable.
pi@openplotter:~ $