2019-06-20, 02:41 PM
Hi, beholder!
Ok. I've got my IBT_2 in. I've decided to build this starting from the motor working back to the pypilot. I'm going to work with a serial connection to the controller at first, and try to make wifi work later.
I'd like to know if the Arduino Nano you are working with is Ver.3, or some other? (This may not matter, but I'd like to clone your model as closely as I can).
Could you post a few images of your breadboard wiring so far? That would be a terrific help! Also a diagram of your voltage divider would be very helpful. I know you aren't yet confident of the correctness of your set-up, so I will go slowly, and cross-check the work with an engineer friend here before I power things up. I'll post back whatever I learn.
Thanks again for your help!
Ok. I've got my IBT_2 in. I've decided to build this starting from the motor working back to the pypilot. I'm going to work with a serial connection to the controller at first, and try to make wifi work later.
I'd like to know if the Arduino Nano you are working with is Ver.3, or some other? (This may not matter, but I'd like to clone your model as closely as I can).
Could you post a few images of your breadboard wiring so far? That would be a terrific help! Also a diagram of your voltage divider would be very helpful. I know you aren't yet confident of the correctness of your set-up, so I will go slowly, and cross-check the work with an engineer friend here before I power things up. I'll post back whatever I learn.
Thanks again for your help!