Raspberry Pi 4 released!

[Didier B]

Or if sigK is working could you add an input type 0183, source serial?

This does not seem to work, says it cannot read property 'pipe' of undefined


Only way I have been able to get it to work is to add a serial connection withing opencpn, would love to get this working in OP

For me it worked nicely (my usb gps is an Ublox-8) : 

• in SK : Added one connection, input type NMEA, Enabled Yes, Logging YES, serial port : /dev/ttyACM0, Baud rate : 9600, Validate checksum Yes, Apply, Restart ;
  
• Then added in OpenCPN Options, tab Connection, Add Connection, network, input, TCP, Address : 10.10.10.1:10110, port 2927, priority 1, OK, and worked perfectly ... 
  

(beginner's luck, maybe ...)

well something is amiss... 10.10.10.1:10110 is basically saying "localhost"  port 10110 and then adding port 2927? shouldn't it be 2947?
also everything I have read says to use /dev/ttyUSB0  

Which instructions did you follow .... there is a lot of conflicting posts our there re Opencpn and openplotter and how to do this correctly.

also when you say NMEA do you mean 2000 or 0183?

I have it working but only through opencpn, and only via the serial connection, I read this is not correct and it should be done through SK... not sure why it matters... would be great to understand why

You are right Rastam4n, excuse my clerical mistake, it is 2947, not2927, and in my post NMEA means NMEA0183, SK only offers me the choice between /dev/ttyAMA0 and /dev/ttyACM0, no /dev/ttyUSB0...
The only help I got was by the fellow's posts in this  thread, specially : https://github.com/SignalK/signalk-serve...eal-inputs
Ii seems important to restart SK server after any change in the configuration ...