Raspberry Pi 4 released!

[Sailoog]

Once again
You do not need any connection in opencpn but the input TCP localhost 10110. Remove any one else.
You have to create the connection TCP localhost 20220 in SK.

Remember that Signal K is the heart of this, it is in charge of getting all data from everywhere. Opencpn only listen at TCP localhost 10110. In OpenPlotter 2 there is a useful tool in openplotter settings called "check system". There you will get important clues of what is wrong in your system (pypilot no implemented yet).

Hi Sailoog

I understand about opencpn, I have one connection in the opencpn connection tab which is localhost 10110

I have added a connection in signal k for 1. ttyUSB0 and 2. localhost 20220. 

The connection to 20220 is giving errors, "connect ECONREFUSED 127.0.0.1:20220

check system is not reporting any problems


 "(pypilot no implemented yet)"  what does this mean? I understand that the autopilot function is not working but for IMU only it is, I can see the data the IMU is working and it is calibrated. 

is it set to refuse connections from signal k? I don't understand to enabling the IMU if the data is not accessible?

ops, shit. sorry, it is my fault.

TCP is not the connection you have to create in SK. You have to create UDP localhost port 52000 to get IMU data in SK.

TCP localhost 20220 will be the connection for autopiot and it will be NMEA 0183 (not working yet).

sorry again, too much in my head...