2019-08-20, 08:44 PM
(This post was last modified: 2019-08-20, 10:50 PM by seandepagnier.)
I just finished the layout for a new version which is much more compact (40x42x20mm) and also higher power (hopefully works for up to 10-12 amp motors) It uses 4 layer PCB.
If the design needs to be flat and skinny or different shapes, it's easily possible but has various tradeoffs. It can also be much smaller and less efficient but ok for small motors, I didn't bother to consider this case much. There are many possibilities.
If the design needs to be flat and skinny or different shapes, it's easily possible but has various tradeoffs. It can also be much smaller and less efficient but ok for small motors, I didn't bother to consider this case much. There are many possibilities.