2019-07-02, 11:54 PM
(2019-07-01, 05:34 PM)michael.trilling@gmail.com Wrote: Hi,
I run op on a rp 3b+. The raspi sets up a boat wifi through which I have all information on several android devicec. Works fine.
In the test setup at home I simple have put a Lan-cable from my routrr into the ethernet port andhsd acsess to the imternet.
Now on the boat I have a ubiquiti bullet m5. That device acts like a router and makrs a wireless connection to any harbour wifi available. Than it has a patch cable to connect to a device on board.
I manage to make the bullet connect to harbour wifi.
But I'm totally lost is the settings to make the bullet work raspberry pi.
Router modus? Bridge? Router? Ap?
Dhcp?
Is the raspberry the client (think so)?
So raspi is Ap + ether1 bridgeted? Or just ap and internet connection on ethernet1?
I'm totally confused....
The attached document is a bit dated but it helped me set up my M2 and contains a lot of good information.
Did you check out the OP documentation on network connections?
https://docs.sailoog.com/openplotter-v1-x-x/network