This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
What type of plugs do you use for rudder connection?
#1
Hi Sean,

I'm keeping my old autopilot as backup and would like to be able to swap the rudder connection easily as they will share the existing rudder sensor.

Seems like the nicest way to do that is put the same type of plug on the cable to the old autopilot, then I can quickly swap the plugs over.

Please could you tell me what the name/type/part number is for the rudder sensor connection plug you used?

Might be useful to know the same for the pilot-motor controller cable plugs too in case I want to add an alternative cableĀ for the pypilot to sit either outside or at the chart table.

Thanks!

Chris
Reply
#2
I was using these mostly:

https://www.aliexpress.com/item/17722280...ab560b4a4f

or

https://www.aliexpress.com/item/32850103...ab560b4a4f



You can find them on other websites as well.
Reply
#3
(2019-07-19, 03:51 PM)seandepagnier Wrote: I was using these mostly:

https://www.aliexpress.com/item/17722280...ab560b4a4f

or

https://www.aliexpress.com/item/32850103...ab560b4a4f



You can find them on other websites as well.

Perfect, thanks Sean. I've ordered some. They'll be useful for other things around the boat too.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)