This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › How do I...? v
Waypoints from InavX to autopilot

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Threaded Mode
Waypoints from InavX to autopilot
hironimus Offline
Junior Member
**
Posts: 1
Threads: 1
Joined: Aug 2016
Reputation: 0
#1
Photo  2016-08-27, 07:59 PM (This post was last modified: 2016-08-28, 09:20 PM by hironimus.)
Hi guys, first my equipment: Ipad with InavX navigation, raspi 3, a usb connected nmea-seatalk bridge (translates all seatalk1 data to nmea183 and viceversa) and running OP 0.8.0. With this constellation i get all nav data from connected Raymarine StT60 instruments on my ipad/inavx. But i could not find a way to send the waypoint data to OP respectively to the ST60 autopilot via usb / nmea bridge. Send data via second tcp adress or different port like in the other thread with opencpn is not possible, see below screenshot from inavx. The yellow lines are the via TCP sended waypoints from InavX. Hoping you have a solution, best regards     
Find
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)