This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Adding LED panel status indicator lights
#1
Hello,


This is a hardware electronics question. Let's say you combined pi and
all input sensors into some kind of enclosure for a cabin computer.
How do you add LED panel status indicator lights. How do you install them,
wire and which statuses you would like to see usually.
I've got various sensors, GPS, AIS, NMEA, USB hubs when all of them are hidden
in enclosure none of their status lights are visible. What are the best way to duplicate them?
Could it be done somehow without a lot of wiring? Might be some kind of fiberglass wires just
picking up light from each light and transferring it to the panel?

Thanks,
--MG

I've found this

How to Connect Optical Fibers to LEDs and Sensors

https://makezine.com/projects/how-to-con...d-sensors/

It would be nice if I could just somehow connect fiber optic wires to all existing LEDs inside
and transmit them to panel. Is this doable?

Thanks,
--MG
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)