This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Node red in OP2
#1
Hi, I installed nodered in openplotter v2, through the installer. To edit a new node or import ahy first to access signal K, with username (pi) and password (raspberry), if it has not been changed before.

As jim321 indicated, to enter node red admin

http: // localhost: 3000 / plugins / signalk-node-red / redAdmin

and to enter the dash

http: // localhost: 3000 / plugins / signalk-node-red / redApi / ui /

When I import a flow or copy the flow file (flows_openplotter.json), when I enter the dashboard address, it indicates that "please add some UI nodes to your flows and redeploy"

The flows_openplotter.json file is created.
any ideas? I use the same flow as previously mentioned.

thanks.
Reply
#2
Hello, after being in these days of confinement, I have returned with node-red.

I answer myself, the problem I had, and in case it serves another person.

I could not open the Dashboar, since in the flow that mattered, there were NODES that I did not have installed, and for that reason, there would be no address to load the dashboard. Once the nodes that you did not have installed are downloaded, they will work.

I think that this did not happen in the previous version, but I am not sure.

Saludos
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)