2019-12-22, 03:28 AM
(2019-12-21, 12:05 PM)Baltic Sailor Wrote:(2019-12-21, 03:50 AM)seandepagnier Wrote: it is also suggested to put a resistor in series with each switch. This is even safer than a single resistor shared to ground for all the switches and prevents shorting the pins if the wrong software is loaded and the pins are set to output.
There are 7 keys for the normal control, but I'm considering adding additional keys to an arduino which communicates to the raspberry on the spi port.
Hi,
just made a prototype board with 5 switches.......
Are the buttons and nokia display are only used for TINYPILOT or can I also connect the switch pad and Nokia display also to Raspberry 3 with OPENPLOTTER?
Which image should I use with OPENPLOTTER and PLUGIN of Pypilot?
It is possible to use this interface with openplotter as well. You should run the pypilot_lcd service. It should be supported by openplotter 2.0:
https://github.com/pypilot/openplotter-pypilot