This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ActiSense NGT-1-ISO connection
#1
I have an ActiSense NGT-1-ISO the output from it is serial RS-232. The ActiSense is connected to a Serial Port to Ethernet converter which allows me to talk to it over my onboard network using WiFi or a hard network connection. However OpenPlotter does not allow for network connections like OpenCPN does. I like this arrangement because this allows me to move the the computer around without restrictions that a NMEA 2000-USB dongle has.

Is there any possibility of adding a network connected serial option to OpenPlotter?

TIA
Reply


Messages In This Thread
ActiSense NGT-1-ISO connection - by RichFind - 2020-01-09, 05:50 PM
RE: ActiSense NGT-1-ISO connection - by tkurki - 2020-06-11, 06:14 PM
RE: ActiSense NGT-1-ISO connection - by RichFind - 2020-06-14, 05:15 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)