(2020-11-10, 06:14 PM)rastam4n Wrote: I am still having some challenges with the use of switches to control TinyPilot. I am using simple momentary switches off on off.I have it like that, without resistor. I assume the internal resistor is activated. A short grounding of the gpio17 activates/deactivates the AP.
I have them wired from ex:pin 11 (gpio17 I believe this is to activate AP) to switch terminal, then from the opposite switch terminal I have a 2,4k resistor and then to ground.
Is this correct?
If you running TP 0.2xx also check also the configuration in the webapp as there you can change the pins function !!!
Save sailing to all
Andreas