2020-02-21, 03:30 PM
nmea0183 is optional for pypilot for wind, gps and route messages.
unfortunately there is not support for buttons on the motor controller, but this may be possible in the future. The motor controller uses a binary protocol.
Otherwise, you can run the buttons to the raspberry gpio with one wire per button plus a ground. Another way is to use an RF transmitter, or a wifi connection to support the buttons.
unfortunately there is not support for buttons on the motor controller, but this may be possible in the future. The motor controller uses a binary protocol.
Otherwise, you can run the buttons to the raspberry gpio with one wire per button plus a ground. Another way is to use an RF transmitter, or a wifi connection to support the buttons.