This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › General discussion v
Moitessier 2 HAT showing as not attached

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Moitessier 2 HAT showing as not attached
lindseygill Offline
Junior Member
**
Posts: 3
Threads: 1
Joined: Feb 2020
Reputation: 0
#3
2020-02-23, 07:50 PM
(2020-02-23, 06:16 PM)Max1947 Wrote: Hi, you must first update the kernel in raspy (if it is not updated: type: "uname -a" to check). Restart and you should find the latest driver (4.19.97-v7) in the HAT. Update the driver. You should reboot and you should be fine! Good wind!  Smile

Thanks Max

I updated the Kernel so it is on the same version as the driver version and I re-installed the driver, which seemed to work as I got a message Firmware Update Successful, but having rebooted the PI I still get the message that the HAT is not attached.

   

   

I'm sure I'm missing something obvious bit I can't figure it out.

All the best

Lindsey
Find
Reply


Messages In This Thread
RE: Moitessier 2 HAT showing as not attached - by lindseygill - 2020-02-23, 07:50 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)