2020-03-15, 02:27 PM
OK, thanks. So I updated to latest versions and removed all serial connections from opencpn. I've since been making all kinds of trial and error attempts at making something happen via what I see others doing in forum posts. One thing I've done is press the UART button in the serial application. It warned me that I'm disabling bluetooth and then rebooted. Now in the serial interface, I see:
ttyUSB0, which I've established in my USB GPS dongle (because it comes/goes when I unplug)
serial8250 ttyS0
fe201000.serial ttyAMA0
Another piece of information: In "Check settings", under "check pypilot", I'm warned "please enable a Signal K connection for Pypilot NMEA 01830 data"
Again, I've made some trial efforts at signal K connections, adding things to Pypilot, adding things to Signal K.
Can somebody point me in the right direction, step by step?
ttyUSB0, which I've established in my USB GPS dongle (because it comes/goes when I unplug)
serial8250 ttyS0
fe201000.serial ttyAMA0
Another piece of information: In "Check settings", under "check pypilot", I'm warned "please enable a Signal K connection for Pypilot NMEA 01830 data"
Again, I've made some trial efforts at signal K connections, adding things to Pypilot, adding things to Signal K.
Can somebody point me in the right direction, step by step?