This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › How do I...? v
HAT2 and breakout board

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Threaded Mode
HAT2 and breakout board
tjmack Offline
Junior Member
**
Posts: 15
Threads: 1
Joined: Nov 2019
Reputation: 2
#1
2020-04-11, 04:28 PM
Hi Group,

I am very new to the OpenPlotter so please bear with a "green" question.

I recently received and installed a Moitessier HAT2 on my RPi3B+. It is working well. However, I previously had a SwitchDoc Labs INA3221 breakout board attached to the GPIO header on the RPi3 to measure boat battery voltages. How would I attach a breakout board now that the GPIO header is used by the HAT?

Thank you in advance for feedback. Tom
Find
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)