2020-08-20, 06:46 PM
(This post was last modified: 2020-08-20, 07:19 PM by waldmattis.)
Good evening to all.
I followed the instructions to install AIS in latest version of openplotter with the exeption of the last point (UDP-port)
In use is a NooElec NESDR Mini 2+ connected to an Raspberry Pi 4
Short calibration manual
But where can I provide an UDP port for my RTL-device?
In SDR VHF 2.1.1 (processes) openplotter-rtl_ais stays inactiv and "dead",
ADS-B dump1090-fa and piaware are activ and "running"
What must/ can I do to get openplotter-rtl-ais activ and running?
Thanks to all.
Karl
Good evening.
The USB-RTL-dongle is recognized in Gqrx, but the "Play"-Button in Gqrx GUI does not effect anything.
How can I get the waterfall in Gqrx?
System is latest Openplotter on a Raspberry Pi 4.
Thanks to all
Karl
I followed the instructions to install AIS in latest version of openplotter with the exeption of the last point (UDP-port)
In use is a NooElec NESDR Mini 2+ connected to an Raspberry Pi 4
Short calibration manual
- Select a device
- Click "Initial PPM" to get an approach to your ppm value. The longer you let the program calculate the better result you will get. If you run the program for hours you will get almost the final ppm but if you do not have time just wait for the value to stabilize.
- Close the program and put the result into the PPM field.
- Select the GSM band for your zone and try to get the strongest channel clicking "Get Channel".
- Put the strongest channel into "Channel" field and press "Get PPM". Put the result into the PPM field again rounding the value without decimals and you are done.
But where can I provide an UDP port for my RTL-device?
- Provide a UDP port to send AIS data to (default 10110). A Signal K connection will be created for that UDP port.
In SDR VHF 2.1.1 (processes) openplotter-rtl_ais stays inactiv and "dead",
ADS-B dump1090-fa and piaware are activ and "running"
What must/ can I do to get openplotter-rtl-ais activ and running?
Thanks to all.
Karl
Good evening.
The USB-RTL-dongle is recognized in Gqrx, but the "Play"-Button in Gqrx GUI does not effect anything.
How can I get the waterfall in Gqrx?
System is latest Openplotter on a Raspberry Pi 4.
Thanks to all
Karl