Hope everyone is safe. Trying to get some fresh eyes on my struggles to get my MPU-9250 working on my RPI4 with V2 of OP (fully updated).
Here's my MPU-9250:
I actually bought 2 of these (since Sean warned that a small percentage will be defective out of box) and results below are same with both.
From my reading, I understand that everything should be auto-detected in pypilot? I believe the IMU is wired up correctly and it is detected at 0x68.
However, it does not show in "Sensors" in the I2C interface:
Pypilot interface shows "Detected IMU: Auto Discover":
Output from "pypilot_boatimu" shows "No IMU detected":
I found this post where a forum member had a similar problem and maybe ran some code from a tutorial. Do I have to do something to get my IMU set up?
Any pointers appreciated?
Here's my MPU-9250:
I actually bought 2 of these (since Sean warned that a small percentage will be defective out of box) and results below are same with both.
From my reading, I understand that everything should be auto-detected in pypilot? I believe the IMU is wired up correctly and it is detected at 0x68.
However, it does not show in "Sensors" in the I2C interface:
Pypilot interface shows "Detected IMU: Auto Discover":
Output from "pypilot_boatimu" shows "No IMU detected":
I found this post where a forum member had a similar problem and maybe ran some code from a tutorial. Do I have to do something to get my IMU set up?
Any pointers appreciated?