2021-03-27, 12:25 PM
I've recently discovered AvNav and been playing with it on a RPi 4 with openplotter at home.
I have an RPi 3 in the garage that is receiving AIS and and a GPS position. I have set these inputs up in signalK (no openplotter on this Pi) and can see all the data just fine. I can see the data in signalK 's webapps on the Pi4 in the house. But I can't see the any data at all on AvNav.
What do I have to do to have OpenPLotter route the data to AvNav?
Can I configure an SignalK input in openplotter?
If not how do I configure SignalK (the one receiving the data) to output NMEA0183 as say a UDP stream?
I can't get my head around creating an NMEA0183 output in signalK.
Any suggestions appreciated.
I have an RPi 3 in the garage that is receiving AIS and and a GPS position. I have set these inputs up in signalK (no openplotter on this Pi) and can see all the data just fine. I can see the data in signalK 's webapps on the Pi4 in the house. But I can't see the any data at all on AvNav.
What do I have to do to have OpenPLotter route the data to AvNav?
Can I configure an SignalK input in openplotter?
If not how do I configure SignalK (the one receiving the data) to output NMEA0183 as say a UDP stream?
I can't get my head around creating an NMEA0183 output in signalK.
Any suggestions appreciated.