2020-05-20, 12:15 AM
(2020-05-19, 12:23 AM)seandepagnier Wrote: you just need to click the enable hardware uart button in openplotter serial settings and reboot.
Thanks - found the button and yes that's a lot simpler but it still doesn't seem to work for me. So:
- Pressed UART button to disable bluetooth etc
- Rebooted RPi-4
- Voltage divider which now supplies 3.3v from Arduino TX to PI-10 (GPIO15)
- Direct connection between PI-8 (GPIO-14) and Arduino RX (so that's still 5v)
- Installed Arduino IDE on RPI, it sees the /dev/ttyACM0 Serial Port now but when trying to upload any sketch: I get 10 errors:
I really am not sure what I'm doing wrong....
Does that matter that ttyACM0 shows up as a device in the OpenPlotter serial list? I guess not as when I delete it the Arduino IDE can't find the port anymore.
Thanks again for your help.