2020-06-05, 08:14 AM
Hi,
When I try to change settings in pypilot Control/client or calibration (tab settings) the changes will not take effect. I run my system with an hydrualic pump that when starting draws quite alot of amps and therefore I need to increase "max_current".
I have tried to tweak this in many ways, including wrinting directly in the pypilot.conf file, but I cannot go beyond 18 amps.
Anyone that can help me in the right direction?
/Joakim
When I try to change settings in pypilot Control/client or calibration (tab settings) the changes will not take effect. I run my system with an hydrualic pump that when starting draws quite alot of amps and therefore I need to increase "max_current".
I have tried to tweak this in many ways, including wrinting directly in the pypilot.conf file, but I cannot go beyond 18 amps.
Anyone that can help me in the right direction?
/Joakim