This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
reboot kills all
#1
New to open plotter.  I'm trying to install 2.0 on a new raspberry pi 4.  I have a 32Gb SD.  Installation goes swimmingly until, it seems at different packages, I get a red "reboot" message not a green "refresh" message. After that the pi will no longer boot.  I've tried this three times and got the same result.

Any suggestions would be greatly appreciated.
thx
Reply
#2
(2020-06-07, 08:00 AM)davidsi Wrote: New to open plotter.  I'm trying to install 2.0 on a new raspberry pi 4.  I have a 32Gb SD.  Installation goes swimmingly until, it seems at different packages, I get a red "reboot" message not a green "refresh" message. After that the pi will no longer boot.  I've tried this three times and got the same result.

Any suggestions would be greatly appreciated.
thx

Hi, try to change the SD ... Cool
Reply
#3
This is a new Raspbian bug: https://forum.openmarine.net/showthread.php?tid=2633
Reply
#4
thank you!

(2020-06-07, 09:39 AM)Max1947 Wrote:
(2020-06-07, 08:00 AM)davidsi Wrote: New to open plotter.  I'm trying to install 2.0 on a new raspberry pi 4.  I have a 32Gb SD.  Installation goes swimmingly until, it seems at different packages, I get a red "reboot" message not a green "refresh" message. After that the pi will no longer boot.  I've tried this three times and got the same result.

Any suggestions would be greatly appreciated.
thx

Hi, try to change the SD ... Cool

I did, same result
Reply
#5
(2020-06-07, 05:39 PM)davidsi Wrote: thank you!

(2020-06-07, 09:39 AM)Max1947 Wrote:
(2020-06-07, 08:00 AM)davidsi Wrote: New to open plotter.  I'm trying to install 2.0 on a new raspberry pi 4.  I have a 32Gb SD.  Installation goes swimmingly until, it seems at different packages, I get a red "reboot" message not a green "refresh" message. After that the pi will no longer boot.  I've tried this three times and got the same result.

Any suggestions would be greatly appreciated.
thx

Hi, try to change the SD ... Cool

I did, same result
Did you follow Sailoog's directions?  https://forum.openmarine.net/showthread.php?tid=2633
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)