RPi 3 Pypilot control via GPIO push buttons

[jamos.tan@gmail.com]

Sean, many thanks.  I have Pypilot 2.0.8 so please can you tell me with service I need and how to load it.  Also, is there a file that defines what each GPIO does?

Not sure if you have the service set-up, but you can run a python script just by adding it in /etc/rc.local:

- start terminal
- sudo nano /etc/rc.local
- Just before the exit command, type the command you run to open the script (usually: python3 /pathtoscript/scriptname.py
- Don't forget to close with & after the script name

Hope this helps until the next version launches.